8S BMS 24V 3.2V 25.6V 100A 200A Active Balance 5A Balancing Current for LiFePO4 Sodium-ion Battery Solar Energy Storage System
An 8S 24V (25.6V nominal) LiFePO4 BMS with a 100A or 200A continuous current rating and up to 5A active balancing manages eight 3.2V lithium iron phosphate cells in series.
It protects against overcharge, over-discharge, overcurrent, and short circuits while transferring charge from high-voltage cells to low-voltage cells.
Key Specifications & Sizing
- Cell & Pack Voltage: 8 cells in series (8S) at 3.2V nominal per cell equals 25.6V nominal (typically 28.4V–29.2V full charge and 20.0V discharge cut-off).
- 100A vs. 200A Rating: A 24V system at 100A delivers roughly 2,560W continuous power; 200A delivers roughly 5,120W continuous power. DALY BMS recommends sizing continuous BMS current to at least 110% of maximum continuous load (and avoiding sizing strictly on average load). Most users on DIY Solar Forum agree in a consensus that builders should size BMS amperage to match the cell bank's full discharge capability and inverter surge needs rather than under sizing to minimal loads.
- 5A Active Balancing: Unlike passive balancing that burns excess energy as heat through resistors, active balancing redistributes charge between cells—making it faster and more effective for larger capacity packs (such as 100Ah–300Ah+) or heavy cycling. Note that many built-in smart BMS active balancers run around 0.6A–2A, whereas 5A balancing often uses a high-current active balancer module or dedicated high-balance-current BMS—verify whether the 5A rating is integrated or an external/paired balancer.
- Thermal & Surge Margin: Eneronix notes accounting for inverter surge currents and applying thermal/safety margins in warm climates.
Important Buying Checks
• Chemistry & S-Count Match: Confirm the unit is specifically calibrated for LiFePO4 (LFP) and strictly 8S.
• Port Type & Comms: Check whether you need common-port or separate-port wiring, plus Bluetooth, RS485, or CAN bus if connecting to a smart inverter or monitoring app.
• Wire Gauge & Lugs: Ensure B-/P-/C- terminals and leads match 100A or 200A continuous current without overheating.
Model Number : BMS 8s
- Current: 200A
- Overcharge protection voltage: 3.7V(can be modified)
- Overcharge release voltage: 3.4V(can be modified)
- Over-discharge protection voltage: 2.5V(can be modified)
- Over-discharge release voltage: 3V(can be modified)
- Active current balancing: MAX 5.5A

