top of page

Esp32-Cam MB Micro-USB programmer is a shield for a standard Esp32-Cam board that adds a Micro-USB port. You just need to plug your board into the shield.

 

Once connected, you only need a USB-micro-to-USB-A cable to connect to your PC or Mac and upload the code. That’s it. Easy, right? To connect to your computer, you’ll need a micro USB cable.

 

It solves the common hassle of wiring an external FTDI or USB-to-TTL adapter by adding a built-in USB port and auto-reset circuitry.


Key Features & Components

• USB-to-UART Chip: Uses a CH340G (or similar) serial converter chip so you can plug a Micro-USB or USB-C cable straight from your computer into the board.
• Onboard Buttons: Includes dedicated RST (Reset) and BOOT / IO0 tactile buttons, making it easy to enter flashing mode without manually shorting pins with a jumper wire.
• Direct Pin Alignment: Designed with a 2.54mm female header socket that matches the pinout of the AI-Thinker ESP32-CAM board for a plug-and-play fit.
• Power Regulation: Features a 5V-to-3.3V voltage regulator and sometimes a voltage selector switch (3.3V/5V).


How to Flash Code Using the Board

1. Dock the ESP32-CAM: Insert your ESP32-CAM module firmly into the female header pins of the programmer board.
2. Connect to PC: Plug a USB cable from your computer into the programmer's Micro-USB / USB-C port.
3. Put into Boot Mode:
    • If your board lacks auto-reset logic, press and hold the BOOT (GPIO0) button, tap the RST button, then release BOOT.
    • On many ESP32-CAM-MB boards, holding/pressing BOOT or grounding GPIO0 during upload initiates the flash.
4. Upload from IDE: In the Arduino IDE:
    • Select your board as AI Thinker ESP32-CAM (under ESP32 Arduino).
    • Choose the correct COM Port assigned to the CH340 driver.
    • Click Upload.
5. Run Your Sketch: Once the upload finishes, press the RST button once (or unplug and re-plug) to restart the ESP32-CAM into normal operation.


Alternatives if You Don't Have a Programmer Board

If you only have a bare ESP32-CAM without the base board, you can program it using:
• FTDI / CP2102 USB-to-TTL Adapter: Wired to 5V, GND, TX->RX, RX->TX, and GPIO0 bridged to GND during boot.
• An Arduino Uno or Nano: Using the Arduino as a passive serial bridge by connecting its reset pin to ground (RST -> GND) and wiring TX/RX.

 

Esp32-Cam MB Micro-USB Programmer board

SKU: C7-1303
UGX 16,000Price
Quantity

    Contact Us

    Grand Plaza Hotel Building , 1st Floor

    Room L15, Mengo Hill Road

    P.O Box 186670 Kampala.

    info@bbiri-centre.com 

    • X
    • White Facebook Icon

    Open: Mon - Sat , 9am to 6pm

    We Accept

    momo Pay

    © 2021-2026 Bbiri Applied ICT Centre Limited              

    bottom of page