Description
This low cost  powerful GPS receiver is based on the famous and high end u-Blox Neo-6M GPS module. It comes with small battery for hot-start and built-in EEPROM too. To offer better signal reception, there is external ceramic antenna that connect to the board via U.FL connector, solid!
The best? It can operate from 3.3V to 5V system, so all those 5V Arduino board (CT-UNO, Maker-UNO, Arduino-UNO, Mega, Leonardo and many more) and 3.3V controller that include Arduino and Raspberry Pi work perfectly with this GPS module. Though it is 5V compatible, you will need a proper level shifter to interface with the serial (UART) line.
 
Technical Specifications:
Power Supply Range: 3 V to 5 V
Model: GY-GPS6MV2
 Ceramic antenna
EEPROM for saving the configuration data when powered off
 Backup battery
LED signal indicator
 Mounting Hole Diameter: 3 mm
 Default Baud Rate: 9600 bps
 Module size 23mm * 30mm
 Antenna size 12 * 12mm
 Cable:20mm
 
Resources:
1. Interface ublox NEO-6M GPS Module with Arduino
2. How Does a NEO-6M GPS Module Work and How to Interface it with ESP32
3. Using and programming a NEO-6 GPS receiver module